H / DESIGN / 무료
3D printer parts and enhancements
사용범위 Creative Commons Attribution Share Alike
사용범위 위반 시 법적 책임을 질 수 있습니다.
Use this instead: https://www.youmagine.com/designs/alternative-um2-feeder-version-two Just my little attempt at a different feeder design.
Other designs are coming from other people but I figured I'd put this up in case someone likes it. I've used it for 50-100 hours or so and it seems to be holding up so far.
Note that you'll need to customize the firmware to run the feeder in reverse. Alternatively you can mirror the print of the body, that might be easier if you're not comfortable mucking around with custom firmware :)
The parts from the original feeder and a few extra M3 screws, a couple of washers and a nut.
A 2cm segment of bowden.
Cooperated with fab365
Powered by L.corporation